At SpaFlo we manufacture all of our products from AISI 316L Stainless steel as it is ideal for the swimming pool and spa industry. This grade of stainless steel ensures maximum corrosion resistance when welding is required due to its lower carbon content over the standard AISI 316 grade.We also fully appreciate the functionality of the filtration system that will run the end product. SpaFlo have been involved in the pool and spa industry for many years and we ensure all our fabrications meet and/or exceed SPATA and PWTAG guidelines to give our clients full peace of mind.
We carefully design every spa pool panel to allow for precision laser cutting of each section before it is welded together. The shell is then encased in a box section frame which adds further structural support and ensures that the finished product sits perfectly level. All of the water and air massage jets, lights, suctions and filtration fittings are clamped and bonded/glued to the stainless steel shell and then fully tested to ensure that the product is fully watertight.Videos are taken of this test and are issued to the client before we finish insulating and wrapping the product ready to be collected and delivered to its installation site.
All of our products are heavily insulated to retain the heat of the water. We also have the capability of delivering the products in sections and completing the final welds on site which allows large products to enter sites through limited accesses.We thrive on designing bespoke vitality spas and hydrotherapy pools as they offer so many health benefits to bathers as well as cost savings throughout the build and lifetime of the installation. To enrich our offerings we can integrate bubbler stations, tubular seating and loungers, volcano air pads, bespoke waterfalls and unique handrails.